Delta Shop Master 1" Belt Disc Sander SA180

If your workshop doesn’t have one of these combination sanders, it’s probably because you don’t think you need it. But put it to work once and you’ll realize you can’t get along without it. Its uses are endless. You know those tight curves and angles you have to sand by hand? Not anymore, thanks to this Shopmaster sander. The automatic belt-tensioning and tracking controls are conveniently located and easy to use, and the built-in power takeoff for a flexible shaft accessory (sold separately) is a great extra touch that allows you to accomplish any number of additional tasks. Finishing curves or odd-shaped work is a cinch when you remove the belt platen, and you’ll even be sanding chamfers and bevels just by tilting the sturdy aluminum tables on either sander. The disc is a fabulous 8 inches, which opens up all kinds of uses. The side panel removes in a blink to change belts. The 1-inch belt sands 3,000 surface feet per minute, and the disc travels at 1,725 rpm for aggressive stock removal, all powered by a 1/3-horsepower induction motor. A built-in dust port allows connection to your dust management system. –Kris Jensen-Van Heste

Delta Shop Master 1" Belt Disc Sander SA180

volts 120

Hp 1/3

Rpm 1720

Phase 1

Hz 60

5 belts

Condition:Like new

Usage: Sanding

Location: Calgary